Domain Name Issue

finid

If you are running Ubuntu 12.04 and you installed Nginx from the repo, you are likely running an old version of Nginx. So, what version of Nginx is installed on the server? Use nginx -v or sudo nginx -v to find out.

rice

@planner

I'm using version 1.1.19

julian

@rice We use the nginx stable PPA to install a newer version

Please note that NodeBB required v1.3.13 or later, if you are using nginx for proxying.

rice

@julian

Thank you so much!!
It worked, I guess nginx wasn't updated enough

julian

Awesome @rice! Glad to hear it.

Updated the nginx article in our wiki to give better instructions.

? Offline

Can someone help a dummy out (me)?

I installed nginx and am at the NodeBB wiki page for configuring nginx as a proxy server. So far I've just been following instructions word for word, but I'm a newb and don't know what to do with this:

NGINX-served sites are contained in a server block. This block of options goes in a specific place based on how nginx was installed and configured:

/path/to/nginx/sites-available/* -- files here must be aliased to ../sites-enabled
/path/to/nginx/conf.d/*.conf -- filenames must end in .conf
/path/to/nginx/httpd.conf -- if all else fails
Below is the basic nginx configuration for a NodeBB build running on port 4567:

server {
listen 80;

etc etc etc

finid

@Kamal-Patel

I think you should start a new topic and make the question clear.

? Offline

@planner

Alright, I can do that. Didn't want to post a new topic since I'm sort of embarrassed -- the original poster seemed to also not have too much knowledge, but even he figured out how to set up reverse proxy.

HolyPhoenix

@Kamal-Patel

The way I found the correct file to update was to look in the /path/to/nginx/conf.d/ file for different files. I don't remember what I saw, but I saw it reference something else that vestacp had created for me under /home/username/web. I went to those files and followed the path even more until I found the actual .conf for the domain I wanted to use and modified the config it had created for me to one that proxies the port. You would be correct that you have to edit a text configuration file, I used nano but I suppose you could use emacs.

When I get home from work I'll see if I can figure out for sure what I did. All I know is that once I found the conf.d folder I was able to trace my way up to the appropriate place.

? Offline

@HolyPhoenix Hold on, did you have a bacon signature yesterday? I made bacon in the oven last night and damn it was crispy! Also, thanks for pointing me in the right direction.