Let’s do this! #3dPrinting
-
#SV08 Small parts box
-
@linux_mclinuxface Be prepared to invest much time in calibration, undoing things, redoing things, fixing things and some more calibration
-
@dalcacer meh. I’ve built printers from scratch and modernized ancient ones. I’m comfortable with that stuff.
-
@linux_mclinuxface Well, then the SOVOL is just great! Enjoy the build up. Ones configured it runs at an insane speed (SV07).
-
@dalcacer yeah, I have a modified SV06 and it’s a joy.
-
All parts accounted for! #SV08
-
#SV08 Z uprights installed. Instructions leave some to be desired: if you followed verbatim it only says to install screws on 2 of 4 ️
(Or maybe I did it wrong!) -
Okay, I think this might be an important missing thing/mistake in the instructions:
When installing the top frame you should really install 1 screw then do the diagonal opposite, then the other diagonal opposites. Kind of like putting wheel bolts on.
The instructions say to do two at a time, which you can, but you could easily cross thread the inserts and make it go out of square. #SV08 #3dPrinting
-
Kyle Davisreplied to Kyle Davis last edited by [email protected]
Gantry and tool head mounted. #sv08
One weirdness: you’re required to remove the fan shroud to mount the tool head. But they have hot glued the JST connector from the factory ️
-
The Teflon tube buckle pinged off. After 5 minutes crawling around on the floor I asked myself “Why is my shop floor practically colour matched to this tiny part?!”