So apparently in 1993, Avon (the MLM (not that MLM (or that kind either))) commissioned a Soft Foam Telephone.
-
I'm getting the expected -51V on the input, so there's no problem with the cord or the PBX powering this
-
and the fuse is fine, I did test that.
-
Here's the translated(ish) schematic from the HM9102D datasheet.
-
I'm gonna assume this device is basically this design with with minimal changes.
-
@foone What a pun!
-
I'm suspicious of this goop. It looks like they hotglued the caps down, so... why would there be brown goop? Maybe these caps leaked out the bottom and it pooled under them.
-
-
xyhhx 🔻 (plz hire me)replied to Foone🏳️⚧️ last edited by
@foone "im suspicious of this goop" is definitely a sentence
-
Riley S. Faelanreplied to Infoseepage #StopGazaGenocide last edited by
@Infoseepage If you write your novel in Chinese, you won't have to use a single letter of e.
-
@foone diagnosis: wrong goop
-
R [email protected] shared this topic
-
C2 & c9 are 47µF 16v caps
C6 & C8 are 100µF 16v caps
C7 is 1µF 50v cap -
Foone🏳️⚧️replied to xyhhx 🔻 (plz hire me) last edited by
@xyhhx FOONE B TURING: GOOP INSPECTOR
-
@cinebox it's like I'm a doctor for a slimegirl, not an electronics repairer!
-
Desoldered them all. Let's test.
My cap meter is saying C7 is 1116nF, or 1.1µF. Close enough for jazz.
-
my MTester thing says it's got an ESR of 7 ohms, which is high, but I don't think this is gonna mind.
-
The two 100µF caps:
c6: 144 µF, ESR 0.5 ohm.
c8: 148 µF, ESR 0.6 ohm.that's a lot higher than they're supposed to be but again, it may not matter with a device this analog.
-
@foone There's a thing, though… Multiple whitespaces in HTML are usually disregarded and considered as only one. The returned text would have to have special chars explicitly telling your browser not to ignore them.
i.e. I think it's more likely either a font problem or a css problem.
I'd suggest trying to run it again elsewhere, if possible.
Best of luck.
-
the 47 µF caps:
c2: 60 µF, 1.3 ohm ESR
c9: 62 µF, 1.2 ohm ESR -
so none of these caps are good, but none are super smoking-gun either. Still, I desoldered them all, so I'm not putting any back. I'll swap them for some new ones once I can order some
-
replacements will be here tomorrow!
