Going mad trying to get this perfect.
-
Going mad trying to get this perfect.
I've leveled the bed multiple times. I've made sure my belts are good. The only thing I haven't done is disassembled and made sure everything was square again. Which is my next step.
#3Dprinting -
@jdm the nozzle is too close to the bed, that much is for sure. Maybe the bed isn't tram to the gantry (either gantry droop or y rail misalignment) Maybe the z offset is too small, maybe the bed is warped (many things like problems with clips can warp a glass bed) maybe the tool head is not rigidly attached enough. Tough to tell from the image. If you have a probe you could look at the mesh it generates and check the variance.
-
@SilentMobius @jdm Also check the bottom side of the glass bed for debris.
I once had a bit of filament under one side of my bed and it was driving me nuts with similar issues.
Copyright © 2024 NodeBB | Contributors