I'm out of ideas on how to #fixmyprint.

Mawoka

I'm out of ideas on how to #fixmyprint. I've attached some photos, but it basically looks like underextrusion at corners. The strange thing: This only occurs with PETG, PLA works completely fine on similar settings. What I've tried so far:
- PA calibration/random tries between 0.01 and 0.2
- Flow rate calibration
- Temp calibration
- different PETG (but from same manufacturer)

What it could be: The 0.6mm nozzle, but what do I have to change?

I'm in desparate need of some tips. Thx

#3dprinting

Mawoka

Oh, forgot one thing: I've printed the exact PETG 2 months ago without any problems on the same printer. Since then, I only swapped to a 0.6mm nozzle

Natasha Nox 🇺🇦🇵🇸

@Mawoka Was the PETG being kept dry during the 2 months? That's always something to consider.