Wrong message shown for invalid username and password
-
You want to install it again. This time with all required npm modules installed and working WebSockets.
Your error can be reproduced by using git clone command instead of using local repo. I mean NodeBB needs to be installed in a different way.
Check your logs for errors.
-
Yes, it can be wrong nginx configuration fault.
At the end of the article they show how to test it.
http://nginx.com/blog/websocket-nginx/If you have had it up and running without an issue it could be something else. In such scenario it could be a problem with plug-ins or themes.
-
@nhl-pl
Thanks for the reply mate.
I found out that the problem was nginx. So I googled and found the following command to remove nginx completelysudo apt-get remove nginx-core nginx-full nginx-light nginx-extras nginx-naxsi nginx-common
After running this command, I installed it back using the sudo apt-get install nginx command and setup the config file as before. But the problem now is I get "page not found" but when I point to the server with the port number, it works. But if I type in without the pot number, it shows the "page not found".
-
@nhl-pl
Hey mate
This is my code in the file.server { listen 80; server_name http://server ip; location / { allow all; proxy_set_header X-Real-IP $remote_addr; proxy_set_header X-Forwarded-For $proxy_add_x_forwarded_for; proxy_set_header Host $http_host; proxy_set_header X-NginX-Proxy true; proxy_pass http://127.0.0.1:4567/; proxy_redirect off; # Socket.IO Support proxy_http_version 1.1; proxy_set_header Upgrade $http_upgrade; proxy_set_header Connection "upgrade"; } }
And I do realise that I didn't have any default config file in the sites-available or the sites-enabled folder.
-
@nhl-pl
I restarted it and got this error
awk: fatal: cannot open file `/etc/nginx/nginx.conf' for reading (No such file or directory)I think this is the reason its not working. Finally made it work. But the problem is:
it shows the same problem as mentioned at the first post at the top "the invalid error name"